共有事項
・マテリアルを一晩装着していると折れやすくなるので、いちいちマテリアルを抜くこと。
・小さい穴のサイズは変動しやすい。
・小さいパーツを作る際は熱容量の関係で綺麗にプリントできないことがある。 パーツの数を増やすなどして、熱を冷ます時間を取るべき。
Printed Item: Sensor Head Parts ( Cylinder x 4)
Operator: Numata
Materials: PLA Black (Single material printing)
Printing Time: 2hours
Printing Result and Error: Hole wich is smallest part of Cylinder, is too small than cad size.
Printed Item: Numata-kun’s Sensor Head Parts (Wide Cylinder x 2 +
Cylinder x 1 + Cylinder x 4)
Operator: sugimoto
Materials: PLA Black (Single material printing)
Printing Time: 3 hours x 2 + 30 min. + 1.5 hours
Printing Result and Error: In the Wide Cylinders and Early Cylinder parts
we could not keep small holes inside of the main bodies. But, by
printing several
parts at the same time, the printing result was greatly improved.
This is due to a thermal capacity issue of printed shapes.
Printed Item: Turtel x 2 (One was in 0.25mm layer mode, the other was
in 0.10mm layer mode)
Operator: sugimoto
Materials: PLA White (Single material printing)
Printing Time: 5 hours + 10hours
Printing Result and Error: The printing quality of 0.10mm layer mode
(left one in the attached picture) was amazing!
Printed Item: Stanford Bunny 7cm
Operator: sugimoto
Materials: PLA White/ PLA Clear
Printing Time: 10hours
Printing Result and Error: O.K., but we might need to adjust the nozzle offset.